Gea+gforce+panel+manual+install - [portable]

You are attempting to install a software version that does not match your specific G-Force hardware generation (e.g., trying to load V2 software on V1 hardware).

| Parameter | Setting example | |-----------|------------------| | IP address | 192.168.1.100 (same subnet as PLC) | | Device name | GEA_Separator_01 | | Baud rate (if RS485) | 115200 | | Machine type | Select from list (e.g., GEA Westfalia MSC 30) | gea+gforce+panel+manual+install

: Require proper piping and isolation valves for maintenance. Slide Valve (LDS) Sensor Typically uses a 4–20 mA output You are attempting to install a software version

Proper grounding is critical for the stability of the microprocessor. Manually assign each physical pin connector to its

Manually assign each physical pin connector to its corresponding sensor (e.g., mapping Pin J242-1 to "Oil Temperature").

: If upgrading an existing panel, back up the current operating parameters to a separate USB drive.