Iprog Rework ^new^ -

Performing a firmware update without the hardware mods above will likely brick your device because the USB bootloader is unstable.

: These are often caused by incorrect pull-up resistors on the mainboard. iprog rework

Replace the current sense resistors with 0.22 Ohm (or three 1 Ohm resistors in parallel) . Performing a firmware update without the hardware mods

Desolder the factory-installed resistor and replace it with a high-precision 4.7kΩ resistor . 2. Resolving 10V / 12V External Power Faults iprog rework